1/12
Installing an IEEE-1394 card
Installing an IEEE-1394 card
This document describes how to install an IEEE-1394 card in your HP workstation.
Kit contents
The following components are included in your processor kit:
■ IEEE-1394 (a or b) card
■ Y-adapter power cable
■ Warranty
■ Installation instructions
Before you begin
See http://www.hp.com/accessories/workstations to determine the compatibility of this product with
your HP workstation.
Observe warnings and cautions
Å
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of
a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the
risk of injury from a hot component, allow the surface to cool before touching.
Å
WARNING: Any surface or area of the equipment marked with these symbols indicates the presence of
an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed
area.
To Next Page
Need help?
General