d. Fully tighten the remaining pair
2
.
e. Tighten all screws to 6 inch-lbs of torque.
Figure 7 Tightening the heatsink screws
Installing the processor heatsink in the HP xw Workstation series
CAUTION: Ensure that the second heatsink does not crush the electrical wires of the first heatsink
fan.
1. Remove and discard the thermal grease protective liner from the underside of the new heatsink,
and then set the heatsink over the processor.
NOTE: Do not touch the exposed thermal grease when handling the processor heatsink.
10 Second Intel® Xeon® processor installation ENWW
To Next Page
Loading...
