6. Attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive as shown in the
following figure.
Figure 4-61 Attaching the SAS-to-SATA adapter
7. Push the drive into the selected bay until it snaps into place (1) as shown in the following figure.
Figure 4-62 Installing the SAS hard drive
8. Attach a power cable (2) to the drive, and attach a data cable (3) from a SAS connector on the
system board to the SAS hard drive.
Use lower-numbered SAS connectors first on the system board. To identify SAS connectors, refer
to the workstation service label on the side access cover.
9. Replace the side access cover.
100 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
