●
If there is a plastic plug in the second processor heatsink hole, ensure that the processor
socket handle is raised (1), and remove the plug (2), as shown next.
Figure 4-74 Removing the plastic plug
7. Align the notches in the processor base with the tabs on the socket as shown in the figure below.
Seat the processor into the socket. Ensure that the underside of the processor is level with the top
of the processor socket.
Figure 4-75 Seating the processor
8. Close the processor cover plate by lightly pressing down on the processor cover plate while closing
the socket lever.
9. Replace the processor heatsink, and then close the side access cover.
System board
This section describes removing and installing the system board.
110 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
