To test the power supply:
1. Unplug the AC power.
2. Disconnect internal power supply cables from the system board.
3. Plug in AC power and verify the following:
●
If the green LED (illustrated below) on the rear of the workstation is illuminated and the fan is
spinning, the power supply is functional.
●
If the green LED is not illuminated or the fan is not spinning, replace the power supply.
Figure 5-1 Testing power supply with LED
Table 5-3 Power supply problems
Problem Cause Solution
Power supply shuts down
intermittently.
Power supply fault. Replace the power supply.
Workstation powers off and the
Power LED flashes red 2 times
(once every second), followed by a
2-second pause.
Processor thermal protection
is activated.
A fan might be blocked or not
turning.
OR
The processor heatsink fan
assembly is not properly
attached to the processor.
1. Ensure that the workstation air vents are not blocked.
2. Open the access panel and press the workstation
power button.
3. Verify that the system fan is running.
4. Verify that the processor heatsink fan spins.
If the heatsink fan is not spinning, verify that the fan
cable is plugged into the system board connector.
Verify that the fan is properly seated.
5. Replace the processor heatsink.
Power LED flashes red (once every
2 seconds).
Power failure (power supply is
overloaded).
1. Determine whether a device is causing the problem
by performing the following:
a. Disconnect AC power.
b. Remove all attached devices.
c. Power on the workstation.
If the system enters the POST, perform the following:
ENWW Customer Self Help 119
To Next Page
Loading...
