4. Unlatch the plastic snap that secures the cables inside the chassis (1) as shown in the following
figure.
Figure 4-10 Removing front panel I/O device cables
5. Disconnect the front panel I/O device assembly cables from the system board (2).
6. Using the following figure, remove the three smaller Torx screws that hold the front panel I/O device
assembly and bracket to the chassis (1).
Figure 4-11 Removing the front panel I/O device assembly
NOTE: Although not required, you can separate the mounting bracket from the front panel I/O
device assembly by removing the two larger Torx screws (2).
7. Pull the front panel I/O device assembly out about two inches from the chassis.
8. Pull the front panel cables through the chassis and through the front of the workstation.
You might need to slide the cables out one at a time.
62 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
