5. Disconnect the power button assembly cable from the system board as shown in the following
figure.
Figure 4-13 Removing the power button assembly cable
6. Disconnect the speaker wire and the hood sensor from the in-line connectors on the power button
assembly cable.
7. Remove the screw that secures the power button assembly to the chassis (1) as shown in the
following figure.
Figure 4-14 Removing the power button assembly
8. Pull the power button assembly away from the front of the chassis, and then rotate the assembly
out from the front of the chassis (2).
To replace the power button assembly, reverse the previous steps.
Optical drive
This section describes how to remove and install an optical disk drive.
64 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
