4. Push gently outward on the socket levers (1) as shown in the following figure.
Figure 4-24 Removing a memory module
5. Lift the DIMM straight up and out of the socket (2), then store the DIMM in an antistatic bag.
Installing a memory module
This section presents system board memory module installation information.
DIM slot identification
The following illustration identifies the system board memory slots:
Figure 4-25 Identifying DIMM slots
Required system board DIMM installation order
Use the figure below as a guide for installing memory:
●
If installing only one DIMM, install it in socket 1.
●
If installing only two DIMMs, install them in socket pair: 1/5.
ENWW Removing and replacing components 75
To Next Page
Loading...
