9.
Remove the power supply from the chassis. Remove the four screws 1 from the back panel.
Slide the power supply toward the front and lift up 2 to remove it from the chassis.
10. If the workstation is equipped with a liquid cooling unit, see section 3.4 for instructions on
draining the fluid.
11.
Rotate the system board latch lever 90 degrees 1 clockwise to unlock the system board. Slide
the system board forward 2 to disengage the metal mounting standoffs from the chassis. Lift
the system board out 3 of the chassis. You can lift the board by the rear audio connector and
the 2 x 4 power connector
4.
12. Dispose of all removed components according to regulatory requirements.
1
2
EL-MF877-00 Page 7
Template Revision A 438710-001
To Next Page
Loading...
