HP Z840 Workstation - Page 16

16
Technical white paper | HP Z840 Workstation
For the latest commands use “/?” option when executing the command.
Example:
> RCfgSata.exe /? Press Enter
Results in:
Intel® RAID Utility for Serial ATA - vn.n.n.nnnn
RCfgSata.exe [/?] [/Y] [/Q] [/C:vol_name] [/SS:strip_size] [/L:raid_level] [/S:vol_size] [/DS:disk_id] [/D:vol_name] [/X]
[/I] [/P] [/U] [/ST] [/V]
/? Displays Help Screen. Other options ignored.
/Y Suppress any user input. Used with options /C, /D, & /X.
/Q Quiet mode/No output. Should not be used with status commands.
COMMANDS - Only one at a time.
/C Create a volume with the specied name.
/S, /DS, /SS, & /L can be specied along with /C.
/SS Specify strip size in KB. Only valid with /C.
/L Specify RAID Level (0, 1, 10, or 5). Only valid with /C.
/S Specify volume size in GB or percentage if a ‘%’ is appended.
Percentage must be between 1-100. Only valid with /C.
/DS Selects the disks to be used in the creation of volume.
List should be delimited by spaces.
/D Delete Volume with specied name.
/X Remove all metadata from all disks. Use with /DS to delete metadata from selected disks.
/I Display All Drive/Volume/Array Information. /P can be specied.
/P Pause display between sections. Only valid with /I or /ST.
/U Do not delete the partition table. Only valid with /C on RAID 1 volumes.
/ST Display Volume/RAID/Disk Status.
/V Display version information.
4. RAID creation from a Windows Administrator Command Prompt.
RAID arrays can be created by using the Intel® Rapid Storage Technology enterprise (RSTe) Command Line Interface
(RSTCLI) for 32-bit and 64-bit Windows operating systems. RSTCLI is included in the Intel® RSTe driver package for
your system, downloadable from hp.com. The RSTCLI must be executed from an administrator command prompt. If
you attempt to execute the RSTCLI utility from a non-administrator command prompt, you will receive the following
message: “Could not obtain system information to display middleware version.”
See the RSTe CLI Specication included with the RSTCLI for specic usage instructions.