HPA B 225 Evo - User Manual

Cod. 4-119451B del 03/2018
EQUILIBRATRICE
WHEEL BALANCER
ÉQUILIBREUSE
AUSWUCHTMASCHINE
EQUILIBRADORA
B 215 Evo
B 225 Evo
Italiano Manuale d’uso
English Operator’s manual
Français Utilisation et entretien
Deutsch Betriebs und Wartungsanleitung
Español Uso y mantenimiento
Tel. +39 0522/736087 - Fax 0522/736716
www.hpa-faip.it - e-mail: info@hpa-faip.it

Summary

Installation

Fixing the Machine to the Ground

Procedures for securing the wheel balancer to the floor.

Electrical Hook-Up

Safety Regulations

Main Features

General Conditions of Use

Switching On the Machine

Balancing Programme Selection

Entering Wheel Dimensions (ALU1 P and ALU2 P Programmes Excluded)

Entering Wheel Dimensions in the ALU1 P or ALU2 P Balancing Programmes

Balancing Weight Application

Applying Balancing Weights in ALU1 P or ALU2 P Programmes

Programme for Positioning the Weights Behind the Spokes Hidden Weight (Only with ALU IP and ALU 2 P Programmes)

Program for Splitting the Weight on Either Side of the Spoke Split Weight (Only with Motorcycle Programmes)

Unbalance Optimisation Programme “OPT”

General Configurations - Set Up

Set Up - Selecting Vehicle Type (Car-Motorcycle)

Configuration for enabling motorcycle wheel balancing functions.

Set Up - Selecting the Mode for Acquiring Wheel Dimensions in the ALU1 and ALU2 Balancing Programmes (Only the Machine Version with Manual Sensor)

Selects how wheel dimensions are acquired for ALU1/ALU2 programs.

Automatic Position Search (RPA)

Set Up - Adhesive Weight Application Position

Unbalance Calibration with Calibration Weight

External Mechanical Sensor Calibration (If Installed)

Messages on the Displays

- E - Error Messages

Other Messages

Troubleshooting

The Machine Does Not Switch On

Troubleshooting steps for when the machine fails to power on.

The Machine Plug is Defective

Measured Diameter and Width Values Do Not Match Rim Values

Addresses discrepancies in automatic measurement readings.

External Mechanical Sensor Not Calibrated

Automatic Measuring Devices Not Working

Troubleshooting for non-functional automatic measuring devices.

Start Key Pressed, Wheel Does Not Spin

Solutions for when the machine does not start after pressing the START key.

Unsteady Unbalance Values

Addresses unsteady unbalance readings.

Machine Does Not Rest Firmly on Floor

Machine Not Calibrated Correctly

Incorrect Geometric Data Entered

Steps to verify and correct entered geometric data.

Maintenance

HPA B 225 Evo Specifications

General

Brand	HPA
Model	B 225 Evo
Category	Wheel Balancers
Language	English