Need help?Do you have a question about the HPC POWER SPEEDEX 9180MC and is the answer not in the manual?
Steps for inserting, positioning, and adjusting keys for accurate cutting.
Instructions on proper key placement in jaws and shoulder/tip gauging.
Procedure for switching the machine's jaws to accommodate different key types.
Demonstrates various methods for holding and calibrating keys.
Steps to flip the gauge arm and turn on the machine for cutting.
How to release the carriage and engage the copy dog for cutting.
Guidance on the correct cutting direction and performing a finishing pass.
Steps to complete the cut and deburr the key using the brush.
Selecting matching key blanks and securely clamping them into the jaws.
Releasing carriage, engaging cutter, and initial depth setting.
Loosening clamp, adjusting depth screw, and retightening.
Cutting a test key and checking its fit to fine-tune depth.
Choosing key blanks and loading one into the tracer side jaw.
Positioning and tightening both keys for accurate space calibration.
Aligning the tracer key with the copy dog for measurement.
Loosening key, scraping shoulder, checking spacing, and moving carriage.
Lining up tracer key and adjusting gauge arm if needed.
Moving gauge using wrench and confirming final adjustment.
Unplugging, removing components, and orienting the guide for flat steel.
Inserting copy dog, engaging gib screw, and reassembling.
Removing guards and using specific wrenches for the cutter shaft.
Steps to loosen and remove the cutter nut, washer, and cutter.
Notes on washer thickness, configurations, and cutter rotation.
Procedures for installing new washers and the flat steel cutter.
Installing and tightening the cutter nut and replacing the guard.
Plugging in the machine and gauging the key tip.
Tightening keys, gauging against cutter, and moving carriage.
Instructions for making vertical plunge cuts on the key.
Finishing plunge cuts and removing any remaining material tangs.
Illustrated breakdown of machine components with numerical references.
Detailed list of machine parts with stock numbers for ordering.
Guidelines for lubrication, cleaning, and warranty information.
Contact details and procedures for machine repair and service.
General| Number of Drives | 9 |
|---|---|
| Maximum Write Speed (CD) | 48x |
| Copy Speed (CD) | 48x |
| Power Supply Type | Internal |
| Model | 9180MC |
| Supported Formats | DVD-R, DVD+R, DVD-RW, DVD+RW, DVD-R DL, DVD+R DL, BD-R, BD-RE, BD-R DL, BD-RE DL, CD-R, CD-RW |
| Supported Disc Types | 12cm |
To Next Page
