HPM EF200SQ User Manual

1 Installation
1. Determine position in ceiling
where the Exhaust Fan is
required to be installed. (Do not
install within 120cm of stove or
inside a shower recess).
Be certain that the installation
area is not restricted by roof
beams above ceiling.
5. Remove grille and insert unit
into hole.
6. Tighten the screws until the
sliding clamps securely grip the
ceiling material.
7. It is recommended that the
three sliding clamps be checked
for the correct clamping by
inspection from above.
8. Push grille into unit and click
into position.
2. Use template provided to draw
a circle – Cat EF200: 242mm,
Cat EF250: 298mm.
To do this insert a thumb tack
in hole at one end and insert
a pencil in the other hole and
scribe a circle.
3. Use electric jig saw or small
hand saw to cut out around this
line. Several holes drilled at a
point inside the circle provides
a convenient starting point for
cutting the panel out.
4. The Exhaust Fan is supplied
with lead and 2 pin plug.
Ensure that a power outlet is
installed near the fan. (This
outlet may be controlled by a
standard switch or time delay
switch.) Check power to the
outlet is off. Plug the fan into
this power outlet.
Ceiling Exhaust Fan
200mm and 250mm
200mm models: Cat. EF200RDWE, EF200SQWE, EF200RDMS
250mm models: EF250RDWE, EF250SQWE, EF250RDMS
Instruction Sheet
EF200RD and EF250RD EF200SQ and EF250SQ

HPM EF200SQ Specifications

General

Brand	HPM
Model	EF200SQ
Category	Fan
Language	English

Summary

Installation Guide

Determine Ceiling Position

Select the fan installation spot, avoiding stoves/showers and checking for roof beam obstructions.

Mark Cut-out Circle

Use the provided template to scribe a precise circle for the fan's ceiling cut-out.

Cut Ceiling Opening

Cut out the marked circle using a saw, creating an opening for fan installation.

Connect Power Supply

Ensure power is off, then plug the fan into the nearby power outlet.

Insert Fan Unit

Remove the grille and carefully insert the fan unit into the ceiling opening.

Secure Fan Clamps

Tighten screws to ensure the unit's sliding clamps securely grip the ceiling material.

Verify Clamp Security

Inspect from above to confirm the sliding clamps are correctly securing the fan.

Attach Fan Grille

Push the grille into the fan unit until it clicks firmly into place.

Product Specifications

Box Contents

Safety Warnings and Information

General Warnings

Ensure fan is off before cleaning; means for disconnection must be in fixed wiring.

Disclaimers

Product must be installed as per instructions; intended for household use, no serviceable parts.

Warranty Information

Product warranted for 3 years; consumer guarantees apply for major failures.