HPRT HT800 Quick Start Guide

-1-
Note: The interface shown in the figure above is for reference only.！
Note: The packing items are actually based on the order. ！
-2-
Appearance and Components
Packing List
FCC WARNING：
This device complies with part 15 of the FCC Rules.
Operaon is subject to the following two condions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause unde
sired operaon.
Any changes or modificaons not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against
harmful interference when the equipment isoperated
in a commercial environment. This equipment
generates, uses, and canradiate radio frequency
energy and, if not installed and used in accordance
with the instrucon manual, may cause harmful
interference to radio communicaons. Operaonof
this equipment in a residenal area is likely to cause
harmful interference in whichcase the user will be
required to correct the interference at his own
expense.
-- Reorient or relocate the receiving antenna.
-- Increase the separaon between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV tech
nician for help.
To maintain compliance with FCC’s RF Exposure
guidelines, This equipment should be installed and
operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
Quick Start Guide
Xiamen Hanin Co., Ltd.
ADD: No.96, Rongyuan Road, Tong'an District, Xiamen, Fujian, China 361100
WEB：www.hprt.com
AC AdapterPrinter
Label Roll CD
Power Cord
Quick Start Guide
USB Cable
Cauon:
In a domesc environment this product may cause radio
interference in which the user may be required to take
adequate measures.
⑤
②
④
①
③
⑫
⑪
①Power Buon
②Indicator Light
③Printer Cover
④Feed Buon
⑤Cover Open Levers
⑥Front Label Sensor
⑦USB Port(Type B)
⑧Serial Port
⑨Power Receptacle
⑩Ethernet Port
⑪Moveable Roll Holders
⑫Locking Tab
⑬Mechanism Lock
⑭Moveable Label Guides
⑮Label Sensor
⑯Platen
⑰Printer Mechanism
⑬
⑭
⑮
⑰
⑯
HT800/HT830
Ribbon Spindles
Ribbon Core
Ribbon
⑦
⑥
⑧
⑨
⑩

HPRT HT800 Specifications

General

Brand	HPRT
Model	HT800
Category	Barcode Reader
Language	English