What to do if my HQ Power PAR56 Projector fixture has no power?
If your HQ Power Projector fixture isn't powering on, first ensure the mains are active. Then, inspect the fixture's fuse to see if it has blown.
What to do if HQ Power PAR56 Projector fixture is not responding?
If your HQ Power Projector fixture isn't responding, verify the DMX settings for correct addressing. Also, check the DMX cables and the polarity switch settings. Finally, check the DMX indicator on the LCD display.
How to fix signal loss in HQ Power Projector?
To resolve signal loss with your HQ Power Projector: * Use only DMX cables. * Install a terminator. * Keep DMX cables separated from power cables or blacklights.
What to do if light will not come on after power failure on HQ Power Projector?
If the light on your HQ Power Projector doesn't come on after a power failure, check the fuse.
Why does the fuse keep blowing on my HQ Power Projector?
To address a repeatedly blowing fuse on your HQ Power Projector, check the total load placed on the fixture.
What to do if HQ Power PAR56 fixture is powered on but there is no movement to the audio?
If your HQ Power Projector fixture is on but not responding to audio, check the audio mode on the LCD display and adjust the sound sensitivity knob.
To Next Page
General