1. With the phone facing
down, insert the tip of the
tray eject tool that came
with your phone (or a small
bent paperclip) into the
nano SIM tray eject hole
that’s on the left side of your
phone.
Push the tip all the way into
the hole until the nano SIM
tray ejects, and then pull the
tray out.
2. Place your nano SIM card
into the tray, with the gold
contacts facing up and cut-
off corner facing out.
Insert the tray back into the
slot. When reinserting the
tray, make sure it is facing
up so that the nano SIM
card doesn’t fall out. Slide
the tray all the way into
the slot.
gold contacts
cut-o corner
nano SIM
2
1
___ Inserting your nano SIM and microSD cards
HTC 10™
IMPORTANT:
Use a standard nano SIM only.
Don’t cut a micro SIM or regular SIM card and insert it into the
nano SIM slot. It’s thicker than the standard nano SIM card and
may get stuck in the slot.
Don’t disassemble any part of the phone.
Don’t try to open the phone or remove the battery by force. This
may damage the phone or its electronics and will invalidate the
warranty.
Don’t throw the provided trays away.
You need them to insert your nano SIM and microSD cards.
To Next Page
