VIVE Tracker (3.0) uses the “Right-handed coordinate system”.
Datum A is set to be the top surface of the ring feature around the 1/4” Screw Nut.
Datum B is set to be the intersection point between the centerline of Standard Camera
Mount (1/4” Screw Bolt) and Datum A.
Datum C is set to be the intersection point between the centerline of Stabilizing Pin
Recess and Datum A.
The coordinate system is constructed by the Datum frame of Datum A, the line of
Datum B and Datum C, and Datum C itself.
To Next Page
Loading...