This section describes software components for the VIVE Tracker (3.0).
If you are an accessory maker, you can transfer a button event through the VIVE Tracker (3.0)
Pogo pin port. You can refer to detailed data format transfer between an accessory and VIVE
Tracker (3.0) in the Data Formats section.
If you are a content developer, refer to Unity integration.
Accessory .
When new firmware for VIVE Tracker (3.0) is released, you can update the firmware by
connecting the tracker to the PC using a USB Type-C cable. Learn how to update the firmware
in Firmware update.
For both content developers and accessory makers:
1. To test VIVE Tracker (3.0) with your content or accessory, you need to have HTC VIVE
as well as the required hardware and software to run it.
2. You need to have a PC with at least one available USB 2.0 port to plug in the dongle
(for use cases with the dongle mentioned in Use Cases) or VIVE Tracker (3.0) (to
update firmware). This PC should also SteamVR installed.
To Next Page
Loading...