Gravity Gaming Phone: 800-900-8809
Page 7 of 9
o This app will report the state of your VR system. Green is good, flashing green
means you aren't tracking (ie, the device can't see the base stations), red is bad, and
grey means off or not connected.
o There will be some helpful alerts that will tell you what to do next.
Double check your headset
If you are getting a Headset Not Detected error on SteamVR, or your Headset LED is red and the
displays are dark, do the following:
1. Quit SteamVR
2. Unplug the Power and USB cord from the PC side of the Link Box (not the orange side).
3. Wait a few seconds, then plug the Power and USB cord back into the Link Box. You may
see more drivers install. Wait for this process to finish.
4. Launch SteamVR.
5. You may need to repeat the steps above more than once. If it doesn't work, you can also
try plugging into different USB ports on your PC.
Connect your Controllers
1. Power on your Controllers with the System Button (pictured below).
o Don't worry right now about plugging them in - they should come out of the box
somewhat charged.
o Your controllers will automatically pair to your Headset when turned on for the first
time.
o If your controllers are on but the icons in SteamVR Status are grey, your controllers
may not have paired correctly. Click on SteamVR menu and Click Settings. Click
Devices, then click on “Pair Controller” and follow the instructions to pair your
controller.
To Next Page
Loading...
