| 17
Switching Station MPC1000
3. GETTING STARTED
Before installation, make sure that the inverter as well as the 230 V mains are
switched off and secured against accidental activation. Only galvanically
isolated inverters may be used. Make sure that the neutral conductor is not
connected with the ground conductor;
– Unscrew the screws on the four corners of the device and take off the lid.
– Mount the device to the wall by using the holes at the back side of the
device. Make sure that the device is mounted onto a dry wall.
– Make sure that the cables are mounted correctly, have good contact and
have the correct gauge. Incorrect mounted cables and cables that are too thin
can result in a smouldering fire.
– Secure the cables leading to the device by using cable clips.
The Switching Station MPC 1000 switches between a 230 V input and an
inverter input. The connectors Master and Slave define which of the inputs is
prioritised as a constant power input and which input becomes the alternative
power source. With this option a constant output of 230 V is guaranteed.
To Next Page
Loading...
Need help?
General
