Installation of the wire remote controller please refer to the following：
The wire remote controller must be installed by qualified installation technicians in accordance
with installation drawing instruction, the power should be shut off before installation. Air flow and
away from heating where the wire remote controller is installed. The following is process of
installation.
1 .Insert a minus screw driver into down slot (2 places).
Be careful not to damage the PC board with minus screw driver.
2 .Remove the back cover.
3 .Use two screw(φ4×16) to fasten the back and metal board in the mounting place and tighten
the screw, then link the communication wire.
4 .Fasten top cover into back cover.
5 .Fasten bottom cover into back cover.
ire 3.W Remote Controller Installation
Wire Remote Controller
9
To Next Page
Loading...
