10
How to Use Advanced Functions
Swing function
LED DISPLAY
Clean Function
Press Swing button
The horizontal louver will swing up and down
automatically when pressing Swing button.
Press again to make it stop.
Keep pressing this button more than 2 seconds,
the vertical louver swing function is activated.
(Model dependent)
2s
Keep pressing this button more than 5 seconds,
the indoor unit will display the actual room
temperature. Press more than 5 seconds again
will revert back to display the setting temperature.
Press this button to turn on and turn off
the display on the indoor unit.
5s
Press LED button
Press CLEAN button
Press this button more
than 5 seconds(some units)
Airborne bacteria can grow in the moisture that condenses around heat exchanger
in the unit. With regular use, most of this moisture is evaporated from the unit.
By pressing the CLEAN button, your unit will clean itself automatically. After cleaning,
the unit will turn off automatically. Pressing the CLEAN button mid-cycle will cancel
the operation and turn off the unit. You can use CLEAN as often as you like.
Note: You can only activate this function in COOL or DRY mode.
Swing
LED LED
Clean
Swing
SHORTCUT function
Press SHORTCUT button
Push this button when remote controller is on, the system will automatically
revert back to the previous settings including operating mode, setting
temperature, fan speed level and sleep feature (if activated).
If pushing more than 2 seconds, the system will automatically restore the
current operation settings including operating mode, setting temperature,
fan speed level and sleep feature (if activated ).
To Next Page
Loading...
Need help?
General
