HTW RG10 Series

12
FP function
LOCK function
O
O
O
O
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function(some units).
Due to low frequency operation of compressor, it may result in insufficient cooling
and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while
operating will cancel silence function.
Silence function
Clean
5s
5s
Turbo
Press this button 2 times during one second under HEAT Mode and setting temperature of
17 C/62 F or 20 C/68 F(for models RG10A10(F/H/G)/BGEF).
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
Press this button 2 times during one second under HEAT Mode and setting temperature of
17 C/62 F or 20 C/68 F(for models RG10A10(F/H/G)/BGEF) to activate FP function.Press On/Off,
Sleep, Mode, Fan and Temp. button while operating will cancel this function.
Note: This function is for heat pump air conditioner only.
2
+
Press together Clean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
2s