10
Use a network cable to connect the PC to the management interface of the router.
Configure a management IP address for the router.
The following example sets the management IP address to 192.168.1.1 and mask length to 24 on GE0/0/0.
Step 4
Step 5
Enable the Web server function.Step 6
Please configure the login password (8-128)
Enter Password:
Confirm Password:
In a version earlier than V200R005C30, the system will prompt you to configure a password.
After successful login, you can configure the router on the command line interface. For more information, see the
CLI-based Configuration.
To configure the router using the web-based management system, perform the following steps.
After a login password is configured, this password will be required upon the next login if password
authentication is used on this user interface.
If you forget the login password, restore the password according to the Troubleshooting.
NOTE
<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/0
[Huawei-GigabitEthernet0/0/0] ip address 192.168.1.1 24
[Huawei-GigabitEthernet0/0/0] quit
[Huawei] http server enable
Configure an HTTPS user and set the user level.Step 7
[Huawei] aaa
[Huawei-aaa] local-user admin password cipher Admin@huawei
[Huawei-aaa] local-user admin privilege level 15
[Huawei-aaa] local-user admin service-type http
[Huawei-aaa] quit
[Huawei] quit
<Huawei> save
Start your browser, enter the URL https://192.168.1.1 in the address box, and press Enter to display the
login page.
Step 8
Enter account information.
Enter the user name and password configured in step 7 to log in to the router.
Step 9
You can use the web-based management system to configure the router. For details, see Web-based
Configuration.
To Next Page
Loading...
