Huawei AR100 Series - Using Configured Web Login Settings

To Next Page

To Previous Page

Step 4

Start the browser, enter the URL https://192.168.1.1 in the address box, and press Enter to access the login

page.

Step 5

Enter the user name and password, and click Login to access the web page.

On the web page, you can configure the router. To switch between the Classics web system and the

EasyOperation web system, click Switch Version in the upper right corner. For more information, see the

Web-based Configuration of the product.

If you fail to log in to the web platform, the current software version of the router does not support login using

the default web login settings. In this case, try the method in 8.2 Using the configured web login settings.

8.2 Using the configured web login settings

Use a console cable to connect a PC to the Console interface of the router.

Start the terminal simulation software, create a connection, configure the connected port, and set

communication parameters as follows.

Step 1

Step 2

Press Enter until the following information is displayed. (The following information is only for reference)Step 3

Install third-party terminal simulation software on the PC by referring to user manual or online help.

The password entered in interactive mode is not displayed on the screen.

Before You Start

Transmission rate: 9600

Data bit (B): 8

Parity bit: None

Stop bit (S): 1

Flow control mode: None

In V200R005C30 or a later version, the system will prompt you to enter the default password.

Username:admin

Password:

Info:The entered password is the same as the default. You are advised to

change it to ensure security.

For V300R019C00 and later versions, the default user name is admin and the default password is

admin@huawei.com.

For the other versions, the default user name is admin and the default password is Admin@huawei.

NOTE

For V300R019C00 and later versions, the default user name is admin and the default password is

admin@huawei.com.

For the other versions, the default user name is admin and the default password is Admin@huawei.

Other manuals for Huawei AR100 Series