8
8.1 Using the default web login settings
8 Logging In to the Router for the First Time
Before You Start
Login Procedure
RST
SYS WAN
ACT
Use a network cable to connect a PC to the management interface marked with the Management
silkscreen on the router.
Step 2
Step 3
Step 1
Turn on the power switch on the external power supply and log in to the router after the SYS indicator
blinks once every 2 seconds (indicating that the router is running properly).
RST
SYS
~100-240V;50/60Hz;2A
FE0 FE1 FE2 FE3 FE4 FE5 FE6 FE7
GE0 GE1
CON/AUX
EN EN
2 1
management
OFF
Network cable
GE0
management
Network port
If the Management silkscreen is not found on the panel of the router, find the corresponding
management interface based on the router model.
AR150 series: FE3 (Ethernet0/0/3).
AR160 series: GE0 (GigabitEthernet0/0/0).
AR200 series: FE6 (Ethernet0/0/6).
Assign the PC with an IP address on the same network segment as the router IP address. The available IP
addresses are in the range from 192.168.1.2 to 192.168.1.254, and the subnet mask is 255.255.255.0.
If the web page is displayed abnormally, the browser version may be too low. Upgrade the browser and log in
to the web platform using Mozilla Firefox 12.0 or later, Google Chrome 23 or later, or Internet Explorer 8.0 or
later.
The login page varies according to version.
You can also scan the QR code on the right to watch the video introducing the procedure for logging in to
routers in web mode.
NOTE
To Next Page
Loading...
