Wall-Mounting the Chassis
CAUTION
l When wall-mounting the AR150/200, do not attach rubber pads to the chassis. If the rubber
pads have been attached, remove them.
l It is inconvenient to connect ground cables and network cables after mounting the
AR150/200 chassis on the wall. Therefore, it is recommended that you connect cables before
mounting the chassis on the wall. If the chassis has been mounted on the wall, hold the chassis
when connecting cables, preventing it from being detached from the wall. For the method of
connecting cables, see 2.3 Connecting the Device.
l When connecting cables, do not make the front plastic panel of the chassis touch the ground
to avoid damage.
l It is recommended that you wall-mount the AR150/200 with its front panel (with indicators)
facing up and its rear panel (with interfaces) facing down.
l Use a ladder when mounting the chassis on the wall.
1. Use the template on the last page to mark the location for the two mounting screws and the
upper, left, and right edges of the chassis on the wall.
2. The diameter of the mounting screws is 4 mm. Choose an appropriate drill bit according
to the diameter of the mounting screws. Hammer the hollow wall anchors into the drilled
holes. Screw the mounting screws into the wall anchors using a screwdriver. Leave the
screws protruding 2 mm from the wall.
Huawei AR150&200 Series Enterprise Routers
Quick Start Guide 2 Product Installation
Issue 03 (2012-06-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16
To Next Page
Loading...
