Installing the Chassis in a Cabinet or Rack
CAUTION
l When installing the AR150/200 in a cabinet or rack, do not attach rubber pads to the chassis.
If the rubber pads have been attached, remove them.
l The guide rails or trays are not necessary for the installation in a cabinet or rack because the
AR150/200 chassis can be fixed by rack-mounting brackets. Customers need to buy the rack-
mounting brackets.
l It is recommended that you install the AR150/200 with its front panel (providing indicators)
facing inside and its rear panel (providing interfaces) facing outside. The rack-mounting
brackets are installed at the sides of the rear panel (providing interfaces) facing outside.
l Ensure that the air exhaust vent is not obstructed in any way. Otherwise, the chassis may
overheat.
1. Install two rack-mounting brackets. It is recommended that you install the rack-mounting
brackets close to the rear panel (providing interfaces). Install two rack-mounting brackets.
It is recommended that you install the rack-mounting brackets close to the rear panel
(providing interfaces).
Huawei AR150&200 Series Enterprise Routers
Quick Start Guide 2 Product Installation
Issue 03 (2012-06-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18
To Next Page
Loading...
