Huawei FusionCharge SmartLogger3000 - Page 7

6
Connecting the Ethernet Cable
3.5
•
The SmartLogger can connect to an Ethernet switch, router, or PC over a WAN port.
•
The SmartLogger can connect to a SmartModule or PC over a LAN port.
•
If the delivered Ethernet cable is too short, you are advised to prepare one of Cat 5e or
higher specifications and shielded RJ45 connectors. The recommended communication
distance is less than or equal to 100 m. When crimping the Ethernet cable, ensure that the
shielding layer of the cable is securely connected to the metal shell of the RJ45 connectors.
(1) White
-and-
orange
(2) Orange
(3) White
-and-
green
(4) Blue
(5) White
-and-
blue
(6) Green
(7) White
-and-
brown
(8) Brown
Installing the SIM Card and 4G Antenna
3.6
•
Prepare a standard SIM card (size: 15 mm x 25 mm; capacity ≥ 64 KB).
•
Install the SIM card in the direction shown by the silkscreen on the SIM card slot.
•
Press the SIM card in place to lock it. In this case, the SIM card is correctly installed.
•
When removing the SIM card, push it inward to eject it.
1. Open the door of the heat exchange compartment of the power unit, remove the protective
cover upward, and remove the sealing putty so that a cable can be routed into the electrical
compartment through the cable box.
2. Route the cable of the newly installed antenna from the cable hole on the top into the power
unit along the original antenna cable route.
3. Seal the cable hole using sealing putty.