19
Step 3 Move the computer closer to the HG658.
Step 4 Place the HG658 and the computer in another direction.
Step 5 Try to avoid using wireless network connection during
thunderstorms.
What can I do if the wireless network is not encrypted but the computer
cannot connect to the wireless network?
Step 1 Delete wireless network configuration from the computer.
The following example uses a computer running the Window XP
operating system:
1. Choose Start > Control Panel. Double-click Network
Connections.
2. In the Network Connections window, right-click Wireless
Network Connection, and choose Properties.
3. In the Wireless Network Connection Properties dialog box,
click the Wireless Networks tab.
4. In the Preferred Networks area, select a wireless network, and
click Remove.
5. Delete all the other wireless network connections from the
Preferred Networks area.
6. Click OK.
Step 2 Set up an unencrypted wireless network connection.
Does the WPS function have any special requirements on the wireless
encryption settings of the HG658?
The WPS function can be used only when the security mode of the wireless
network is set to WPA2-PSK, or WPA-PSK/WPA2-PSK, and the SSID is set
to SSID1. It is recommended that you set the security mode to
WPA-PSK/WPA2-PSK.
What can I do if I cannot set up a wireless connection between the HG658
and the computer by pressing the WPS button?
Step 1 Check that only one computer tries to connect to the HG658 using
the WPS function at a time.
Step 2 Check that the wireless network function and the WPS function in
PBC mode are enabled on the HG658.
To Next Page
Loading...
