Huawei SmartAX MA5672 - FAQS and Troubleshooting; LOS Indicator Troubleshooting; PON Indicator Troubleshooting; Device Reset Procedure

7
2
Off
-
The connection between the
MA5672 and the OLT is not set
up.
3
Blinks quickly
(twice per second)
-
The MA5672 is attempting to set
up a connection to the OLT.
4
Always on
-
The connection between the
MA5672 and the OLT is set up.
5
-
Off
The Rx optical power of the
MA5672 is normal.
6
-
Blinks slowly
(once two
seconds)
The Rx optical power of the
MA5672 is lower than the optical
receiver sensitivity.
7
Blinks quickly
(twice per second)
Blinks quickly
(twice per second)
The OLT detects that the device is
a rogue ONU.
5 FAQs
The LOS indicator is blinking.
 When the LOS indicator blinks slowly, check whether the pigtail fiber is connected normally
and whether the optical connector is contaminated.
 When the LOS indicator blinks quickly, check whether the MA5672 transmits optical signals
normally.
The PON indicator is off.
 Check whether the optical fiber is properly connected to the OPTICAL port.
 The MA5672 fails to register with the OLT. Contact the service provider for help.
How to reset the MA5672?
 Press the RESET button by using a needle-type object.
How can I restore factory defaults?
 Press RESET button by using a needle-type object for longer than 10s to restore factory
defaults and reset the MA5672. If the indicator is off and then is lit, the system restarts
successfully.