To Next PageTo Next Page
Need help?Do you have a question about the Hubbell CHANCE and is the answer not in the manual?
General| Brand | Hubbell |
|---|---|
| Model | CHANCE |
| Category | Controller |
| Language | English |
Highlights hazardous voltages, moving parts, and general safety precautions.
Clarifies manual limitations and company policy on product improvement.
Defines a qualified person for installation and maintenance tasks.
States the manual does not cover all details or modify existing agreements.
Manual provides installation guidance for motor operator, covering situations and utility practices.
Only qualified personnel should install, operate, or service this equipment.
Defines DANGER, WARNING, CAUTION signals indicating hazard levels.
Describes the motor operator for overhead distribution switch with reciprocating controls.
Details mounting on utility poles, including considerations for steel or concrete.
Specifies suitability for outdoor installation in temperatures -40°C to +60°C.
Lists electrical, mechanical, and physical characteristics of the motor operator.
Space provided for logging installation, operation, and maintenance details.
Lists required personal safety gear like hard hat and work boots.
Details specific bolts, washers, nuts, and screws needed for installation.
Specifies conductors, conduit fittings, and grounding requirements.
Lists communications equipment and laptop requirements for installation.
Outlines voltage, amperage, and protection needs for the power supply.
Instructions for inspecting packaging for damage upon receipt.
Steps for safely unpacking the motor operator from its shipping crate.
Guidance on comparing received parts against the provided list.
Identifies and locates components within the motor operator enclosure.
Steps to modify the switch handle and prepare for mounting.
Public safety warning regarding minimum installation height.
Procedures for marking and drilling mounting holes on the utility pole.
Instructions for lifting and attaching the motor operator to the pole.
Steps to connect the motor operator to the overhead switch control pipe.
Procedures to verify correct manual operation and coupling.
General rules for routing wires and minimizing noise and ground loops.
Instructions for installing safety ground and surge suppression devices.
Steps for accessing terminal block and preparing power wiring.
Details on connecting 115VAC incoming power to the terminal block.
Details on connecting 230VAC incoming power and modifying wiring.
Steps for reassembling the control box and energizing the unit.
Procedure to reverse the motor's open/close direction if needed.
Steps to turn on power, exercise the switch, and check status lights.
Explains Battery Test and Lamp Test functions on the control box.
Procedures for manually decoupling and coupling the motor from the drive.
Instructions for operating the switch manually using the provided handle.
Overview of operating the switch remotely via RTU and communication link.
Notes that limit switches compensate for motor travel, not switch issues.
Steps to loosen, move, and tighten limit switch thumbscrews.
Guidance on cleaning, painting, and clearing obstructions around the enclosure.
Instructions for testing and replacing the motor operator's batteries.
Information on battery self-discharge and charging requirements.
Troubleshooting steps for enclosure and control box lights.
Information on minor lubricant seepage and its disposal.
Guidance on troubleshooting a non-functional motor operator.
Introduces the table of common symptoms, causes, and corrective actions.
