Need help?Do you have a question about the Hubbell KIM LIGHTING VRB1 and is the answer not in the manual?
General| Manufacturer | Hubbell KIM LIGHTING |
|---|---|
| Model | VRB1 |
| Housing Material | Aluminum |
| IP Rating | IP66 |
| Voltage | 120-277V |
| Color Temperature | 3000K, 4000K |
| Finish | Black, White |
| Certifications | UL, cUL |
Install the base casting on pre-set anchor bolts using flat washers and hex nuts below and above.
Level the top edge of the casting by adjusting the bottom leveling nuts and tighten the upper nuts.
Tighten the upper nuts using a 9/16" deep socket.
Lay fixture horizontally on soft cloth with open end next to installed base casting.
Pull fixture wires out from inside of riser and make connections to field wires.
Place pole body over base casting, twist clockwise 45 degrees to lock onto base casting.
Tighten two 3/8" set screws at the bottom of the pole using a 3/16" hex key.
Warrants material and component parts free from defects for 1 year from sale.
Auxiliary equipment carries the component manufacturer's warranty.
Warrants copper/bronze for 25 years, composite in-grade for 7 years, aluminum for 3 years.
Warranty void if modified, misapplied, or improperly maintained. Excludes labor costs.
To Next Page