3482B 042621
72-00668D
1
NX Lighting Control Panel (NXP2 Series)
INSTALLATION INSTRUCTIONS
PRECAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• CAUTION - RISK OF ELECTRICAL SHOCK. To prevent electrical shock, turn o power at the circuit breaker before installing
or servicing unit. Never wire energized electrical components.
• NOTICE: For installation by a licensed electrician in accordance with national and/or local Electrical Codes and the
following instructions.
• CAUTION: USE COPPER CONDUCTOR ONLY.
• CAUTION: This equipment provides more than one power supply output source. To reduce the risk of electric shock
disconnect both normal and emergency sources within this unit before servicing any equipment connected to this unit.
• Be sure to read and understand all instructions before installing or servicing unit.
• For Indoor use only. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Disconnect switch or a circuit breaker must be provided and marked as the disconnecting device.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Conrm that device ratings are suitable for application prior to installation.
• No user serviceable parts contained inside unit. Refer all service-related questions to the factory.
INSTALLATION OVERVIEW
The installation instructions contained in this document are provided as a guide for proper and reliable installation. The mounting
location should be selected and prepared based on the application. All electrical wiring and mounting hardware (i.e. electrical
mounting box, conduit, etc.) should be prepared with consideration of the requirements outlined in the wiring and mounting
diagrams included in this document.
These instructions include information as follows:
Precautions
Description
Product Congurations
Enclosure Mounting
Installing Individual Relays
Connecting Panel Power
Connecting Lighting Loads
Using the NX Panel for Control of Emergency Lighting
Connecting NX Devices
Connecting Low Voltage Inputs & Dry Contact Outputs
Connecting to Panel Using controlHUBB app and NX Bluetooth® Radio Bridge with Real Time Clock
Connecting Panel to HubbNET™ Network
Troubleshooting
Panel Specications
Panel Load Schedule Form
Wiring Diagrams
Download the controlHUBB app
701 Millennium Blvd. | Greenville, SC 29607 | (864) 678-1000 | hubbellcontrolsolutions.com
Copyright © 2021 Hubbell Control Solutions, a division of Hubbell Lighting, Inc. All rights reserved. All product and company names, logos and product
identiers are trademarks ™ or registered trademarks ® of Hubbell Lighting, Inc. or their respective owners. Use of them does not necessarily imply any
aliation with or endorsement by such respective owners.
To Next Page
Need help?
General
