11.
Installing the
Metal Light Cover
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Position the tabs in the inside of the rim on the
metal light cover so they line up with the notches
on the inside of the rim on the mounting plate.
Carefully lift the metal light cover up inside the
mounting plate and secure it to the fan by turning
the metal light cover clockwise until snug. DO
NOT OVERTIGHTEN. (Fig. 14)
Figure 14
Tabs
Notches
Mounting
plate
Metal light
cover
To Next Page
Loading...