OPERATING INSTRUCTIONS FOG
®
ATOMIZER SPRAYERS
BEFORE USE, READ THIS MANUAL COMPLETELY.
KEEP MANUAL FOR FUTURE REFERENCE.
Models: 99598 and 99599
SPECIAL NOTICE TO USERS
971-220 05/2012
Damage in transit, wearing of nozzles or other parts, temperature, altitude, climatic factors and
manners of use may effect the performance of this equipment. Careful maintenance, approved
calibration procedures and repeated testing of output are necessary for safe and satisfactory
results. Users must determine that the rate of application is proper for the chemical being used
and the conditions under which it is being applied.
H.D. Hudson Manufacturing Company • 1-800-977-7293 • www.hdhudson.com
LIMITED WARRANTY – H. D. Hudson Manufacturing Company warrants to the original consumer purchaser
of this product at retail that it is free from defects in materials and workmanship for the period of 90 days
from the original date of purchase. This warranty does not apply to damage to the product resulting from
accident, misuse, neglect, alteration, modification, tampering, or failure to follow instructions supplied with
the product. This warranty does not cover normal wear and tear of o-rings or seals. If the product or any
part of it should malfunction within the warranty period, call 1-800-977-7293. Valid only in North America.
WARNINGS
• DO NOT operate this sprayer in small, enclosed areas, or any area where any spray or
foreign material could be sucked into the air intake.
• DO NOT overheat the motor. Be sure air intake is kept open at all times.
• DO NOT use this sprayer for paint spraying.
• DO NOT spray gasoline or other flammables.
• DO NOT alter the sprayer.
• DO NOT store chemicals in canister.
• ALWAYS READ AND FOLLOW instructions for chemical to be applied.
• IF SPRAY PATTERN BECOMES IRREGULAR, turn sprayer off, remove the intake
strainer and clean the screen.
• IF CORD BECOMES DAMAGED, it must be replaced before further use.
• DO clean sprayer thoroughly after each use.
To Next Page
Need help?
General