What should I do if my Huebsch Alliance Laundry Systems TR7104WN displays other Er or Ed codes?
If your Huebsch washer displays any other Er or Ed codes, unplug the machine for 15 seconds, then plug it back in. If the code still appears, call for service.
What does error code Er, nF mean on my Huebsch Washer?
The Er, nF code on your Huebsch washer indicates that the washer has not filled to the proper water level. To resolve this, ensure that both the hot and cold water faucets are turned on and that the fill hoses are not kinked or twisted. Also, clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. If the issue persists, unplug the machine for 15 seconds to clear this code.
How to stop water leaks from my Huebsch Alliance Laundry Systems TR7104WN?
To address water leaks from your Huebsch washer, first check that the fill hoses are properly installed on both the faucets and the washer's water mixing valve. Inspect the condition of the fill hoses and replace them every five years. Ensure the drain receptacle is not clogged and check your laundry room plumbing. Also, examine your house water pressure, as extremely low pressure can cause leaks. If you notice excessive suds, try using less detergent or switching to a low-sudsing detergent, and ensure you're using proper load sizes.
Why won't my Huebsch Alliance Laundry Systems TR7104WN fill with water?
Several factors could prevent your Huebsch washer from filling. Ensure the power cord is fully plugged into the outlet, both hot and cold water faucets are turned on, and the lid is completely closed. Check that the fill hoses aren't kinked or twisted, and that the controls are properly set. Press the Start/Pause button to initiate the wash cycle. Also, verify that the last spin cycle has been completed. Examine the laundry room fuse or circuit breaker. Clean the screens in the water mixing valve and the filter screens located at the faucet end of the fill hoses. Ensure the drain hose is properly installed to prevent siphoning. Finally, if you're using flood-safe stainless steel hoses, they might be falsely activating; consider replacing them with the original hoses.
Why does my Huebsch Alliance Laundry Systems TR7104WN Washer not start?
If your Huebsch washer isn't starting, make sure the lid is closed properly and press the Start/Pause button. Ensure the power cord is fully plugged into the electrical outlet and that the controls are correctly set. Check the laundry room fuse or circuit breaker. Also, remember that you must wait five seconds after turning on the washer before you can press the Start/Pause button to start a cycle. A status light will flash during this warm-up period.
What does error code Er, LU mean on my Huebsch Alliance Laundry Systems TR7104WN Washer?
The error code Er, LU on your Huebsch washer indicates that the control senses that the lid will not unlock. Unplug the machine for three minutes to unlock the lid. If the code appears again, call for service.
What does the blinking decimal point mean on my Huebsch Washer display?
The blinking decimal point on your Huebsch washer display indicates that the washer did not reach the maximum intended speed in the final spin. Ensure you are using proper load sizes that are evenly distributed in the wash basket and that you are using high-efficiency (HE) detergent. You can open the lid or press any keypad to clear this code.
What does error code Er, OF mean on my Huebsch Alliance Laundry Systems TR7104WN?
The error code Er, OF indicates that the Huebsch washer has filled to the overflow level. The machine will begin to attempt to pump water out if the lid is closed and locked. If the code does not clear, unplug the machine and call for service.
What does error code Er, dr mean on my Huebsch Alliance Laundry Systems TR7104WN?
The error code Er, dr on your Huebsch washer indicates that water is still in the washer at the end of the cycle. Check the drain hose and drain receptacle to make sure they are installed properly and not blocked. You can also try unplugging the machine for 15 seconds to clear this code.
What to do if my Huebsch Washer won't agitate?
If your Huebsch washer isn't agitating, make sure the lid is closed, and press the Start/Pause button. Check that the power cord is fully plugged into the electrical outlet and that the laundry room fuse or circuit breaker is working. If the drive belt is broken, you will need to call a service person.
Explains DANGER, WARNING, CAUTION, IMPORTANT, and NOTE safety message classifications.
Crucial instructions to prevent fire, electric shock, and serious injury during washer use.
Steps for sorting, pretreating, and correctly loading the washer for optimal wash results.
Details on selecting wash temperature, water supply, and load size for effective cleaning.
Overview of the digital display, idle mode, keypress audio, and descriptions of various wash cycles.
How to adjust cycles using Selections (Temp, Load Size, Soil Level) and Options (Soak, Rinse, etc.).
Guide to starting, running, and pausing a wash cycle, including adding items.
Instructions for using the manual soak feature for heavily soiled garments.
Breakdown of cycle stages, activities, and default timings for common wash programs.
Explains specific wash cycles like Eco Heavy Duty, Waterproof, Super Soiled, and Whites.
Identifies typical washer sounds and explains their likely origins for troubleshooting.
Guidance on using the bleach and fabric softener dispensers and how to clean them.
Solutions for common laundry problems like dingy clothes, yellowing, tearing, lint, and wrinkles.
Procedures for preparing the washer for cold temperatures and winter storage.
Recommended monthly, six-month, and annual checks for washer upkeep.
Instructions for reinstalling shipping brace and plug when moving the washer.
Troubleshooting tips for issues like not filling, not starting, not spinning, and noisy operation.
Explains specific error codes displayed on the washer (e.g., Er, FL, PF) and their resolutions.
How to find authorized service centers and obtain replacement parts for the washer.
General| Brand | Huebsch |
|---|---|
| Model | TR7104WN |
| Category | Washer |
| Voltage | 120V |
| Color | White |
| Type | Top Load |
| Width | 25 5/8 in |
| Depth | 28 inches |
| Height | 42 3/4 in |
| Spin Speed | 300 RPM |
To Next Page