Huffy Sports Basketball Systems User Manual

1
02/04 P/N 21145507
© COPYRIGHT 2000 by HUFFY SPORTS
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
Inground System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
REQUIRED TOOLS AND MATERIALS:
• Two People
• Tape
• Carpenter’s Level
• Wood Scrap
• Wedge
• Phillips Head Screw Driver
• Concrete, 540 lb (245 kg) Minimum and Container to Mix
• Wood Board (Scrap)
• Wrenches: (Two) 7/16”, 1/2”, 9/16”, 3/4” or two Large and Small
Adjustable Wrenches
• Tape Measure
• Shovel and Spade
• Hammer
• Sawhorse or Support Table
• Step Ladder 8 ft. (2.4 m)
• Safety Goggles
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO PROPERTY.
WARNING!

Huffy Sports Basketball Systems Specifications

General

Brand	Huffy
Model	Sports Basketball Systems
Category	Fitness Equipment
Language	English

Summary

Before You Start

Fit Test Components for Optimal Playability

Test-fit large bolts into elevator tubes, backboard brackets, and triangle plates to ensure a close tolerance fit.

Safety Instructions

Height Adjustment Precautions

Adult supervision is recommended when adjusting height. Keep hands and fingers away from moving parts.

Assembly Notices

Ballasting and Weight System

All Huffy Sports Basketball Systems must be assembled and ballasted with sand or water according to instructions.

Parts List

Hardware Identification

Bolts and Screws

Visual guide to identify different bolts and screws used in the system assembly.

Nuts and Washers

Visual guide to identify nuts and washers used in the system assembly.

Steel Spacers

Visual guide to identify steel spacers used in the system assembly.

Plastic Spacers

Visual guide to identify plastic spacers used in the system assembly.

Assemble the Pole

Assemble Backboard to Elevator Tubes

Assembly for 44” Molded Plastic Backboard

Assembly for 48" Molded Plastic Backboard

Assembly for 44” Steel-Framed Acrylic Backboard

Assembly for 48" Molded Plastic-Framed Acrylic Backboard

Attach Backboard/Elevator to Pole System

Install Smart Clips

Net Installation

Adjusting System Height

Apply Height Adjustment Label

Apply the height adjustment label (38) to the front of the pole to indicate regulation rim height.