To Next PageTo Next Page
Need help?Do you have a question about the Hugo Lahme AllFit 1702050 and is the answer not in the manual?
General| Brand | Hugo Lahme |
|---|---|
| Model | AllFit 1702050 |
| Category | Controller |
| Language | English |
Identifies the electronic water level controller, its article number, and key components: switch box, float sensor, and solenoid valve.
Details sensor cable length, extension, LED indicator, switching delay, relay output rating, and low voltage operation.
Crucial safety notice: the concrete protective tube for the connection cable must be mounted before skimmer installation.
Illustrates the system layout with key components like sensor cable, concrete pipe, solenoid valve, and freshwater supply.
Ensures the sensor cable is routed interchangeably within a shielded tube for proper protection.
Mandates professional electrical work per VDE 0100 and the installation of a 30 mA fault circuit interrupter.
Provides a schematic for connecting the switch box, supply line, solenoid valve, and sensor.
Details attaching the float sensor with its bracket to the protective plate and then to the skimmer wall.
Covers routing the sensor cable, connecting it to the switch box, and performing a functional test by moving the sensor.
Instructions for fixing the electronic housing and connecting the magnetic valve and float sensor according to the diagram.
Guidance on mounting the float sensor, its adjustment bracket, protective plate, and routing the sensor cable.
Explains how to set the switch to 'ON', identifies the switching point, notes the solenoid valve delay, and how to simulate a test.
States the electronic water level controller complies with relevant EU directives like EMC and RoHS.
Specifies the harmonized standards applied, particularly EN 6100-1:2016, for product compliance.
Declares sole responsibility for product conformity and states declaration invalidity upon unauthorized technical modification.
