21
9.6 Riding
To increase the power support and to ride faster simply turn the throttle a bit more. At
the same time you need to pedal faster to accelerate the cycle.
To decrease the power support slowly move the throttle back to the zero position.
If you accelerate your pedal frequency will increase as well. You now need to switch
into a higher gear. If you pedal more slowly the power support will be deactivated. If
your riding speed is slowing down,(because you ride uphill) you need to shift down in
gear as well.
If you don’t want any power support of the system while riding the bike, you should
take the following steps:
- Turn the throttle slowly into the zero position.
- Push the „ON/OFF“ button on the throttle for min.1 second until all LED’s are off.
Never block the auto-into-zero position of the throttle during the
ride. This can lead to very dangerous situations!
**With a PAS-vario system using the acceleration option you
can accelerate up to 6 km/h / 3mph without pedalling.
With the Auto-vario system you can accelerate without pedalling
up to 20 km/u.
The power support will
switch off automatically when:
- the battery is empty.
- motor or electronics are overheated.
The overhe
ating of the motor and/or Electronics can be a result
of a heavy load on the cycle or a long trip on a slope. After a
short cool down period, the system will activated
automatically. (ca. 5-10 min).
To Next Page