EasyManua.ls Logo

Hulk HU6511 - Page 5

Hulk HU6511
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING:
Warning. Always properly ventilate the area before attempting to start the
engine, hook up a Jump starter or start the jump starting process DO NOT use
this product near or in the presence of propane tanks, natural gas or any other
explosive fumes that may accumulate, especially in low or enclosed areas.
Note that the lead acid battery may vent potentially explosive gases during
the process of cranking the engine. - ALWAYS KEEP THE AREA WELL
VENTILATED to eliminate potentially explosive gases before performing any
jump starting process.
1. Shield eyes with protective safety glasses or safety goggles.
2. Make sure the ignition switch in the vehicle to be jumped Is in the off position
before attaching cables.
3. Always put the ground (Black) cable on a non-moving engine ground point.
Never connect clamps to the carburetor or fuel Injection system as a ground
point.
WARNING:
DO NOT crank the engine for more than 4 continuous seconds while the unit
is connected to the battery. If the engine fails to crank or start there may be
a problem other than a discharged battery.
4