GENTIS
7
Schlafen: GENTIS E 1. 2021
Concept and possible arrangements
Unit with functional frame for floor
units
The units can be planned optionally with
a functional frame for floor units.
Unit with functional frame for wall
assembly
If you plan a functional frame for wall
assembly, you require an extra wall
bracket. In this case the plinth adjusters
are omitted.
Unit with functional frame on metal
substructure
The units with a functional frame can
be planned optionally on a metal sub-
structure (19.4 cm high). In this case the
plinth adjusters are omitted.
Functional frame
Functional frame for floor units of wood resp. for wall assembly of metal.
Functional frame always in white lacquer.
The functional frame enables the following functions:
• Distance frame for a hovering look
• Inclusion of LED lamp
• Hiding cables
Functional frame
3-sided lighting of functional frame
for floor units
4-sided lighting of functional frame
for wall assembly
LED lamps for functional frame
The functional frame can be fitted with an optional LED lamp.
LED lamp incl. footswitch. Lamp switch optionally with
a remote control unit possible (against surcharge).
LED lamp of the functional frame for floor units:
3-sided lighting
LED lamp of the functional frame for wall assembly:
4-sided lighting
LED lamps for functional frame
Lowboard with end units with drawers
Sideboard with end units with hinge-doors
Drawer and hinge-door for end units
The rounded end units of the low-, side- and highboards can optionally be fitted with drawers
and/or hinge-doors. The sideward distance for the hinge-doors must be 27 cm (per door) to
open doors fully.
Drawer and hinge-door for end units
To Next Page
Loading...
