Need help?Do you have a question about the HULTDINS SuperSaw 350E and is the answer not in the manual?
Explains general safety rules and the meaning of warning symbols.
Explains the meaning of 'Danger', 'Warning', and 'Caution' messages.
Details safety checks and procedures during operation.
Discusses the risk of chain ejection and operator/bystander safety.
Emphasizes safety measures for operators and bystanders from chain hazards.
Outlines safety precautions during maintenance and service work.
Provides instructions and precautions for welding on the equipment.
States what modifications are not approved for the equipment.
Illustrates and lists the main components of the grapple saw.
Shows the location and identifies adjustment valves on the grapple saw.
Identifies hydraulic pressure test points on the grapple saw for testing.
Lists and illustrates the main components of the SuperCut 100 saw unit.
Describes the labeling on the SuperSaw 350E, including serial number and CE-label.
Provides dimensions, hydraulic system specs, and chain lubrication data for the 10cc model.
Provides specs for the 19cc model, including dimensions, hydraulics, and lubrication.
Lists and illustrates special tools required for servicing the SuperSaw 350E.
Presents the hydraulic diagram for SuperSaw 350E, alternative 1.
Presents the hydraulic diagram for SuperSaw 350E, alternative 2.
Describes the main components and functionality of the SuperCut 100.
Explains the operation and components of the chain lubrication system.
Provides guidance on the optimal placement of the grapple saw.
Details the steps for installing the grapple saw onto a SuperGrip II.
Explains how to connect the hydraulic lines for the saw motor.
Provides instructions for starting the saw motor, including pre-checks.
Details the procedure for adjusting the saw bar feed out pressure.
Explains how to adjust the saw bar feed out speed using a restrictor valve.
Describes how to adjust the saw bar retraction speed via air pressure.
Details the procedure for adjusting the chain tension pressure.
Explains how to bleed air from the chain tension system.
Provides step-by-step instructions for replacing the saw chain.
Outlines the process for replacing the saw bar.
Details the steps for replacing the bar holder.
Explains how to replace the drive sprocket and related parts.
Guides on how to refill the chain lubrication oil tank.
Lists specific checks to be performed daily for the unit.
Specifies the lubrication schedule and type of grease for the unit.
Details the cleaning procedure for the chain lubrication strainer.
Provides specific instructions for the first month of operation.
Instructions for tightening fasteners during the first month of operation.
To Next Page
General
