User Manual HUMA Hi-150
Main Functions
1. Control knob
On / Off
You can switch on the device by pressing the control button for 1 second. If the device is not in
off, the LED(2) will blink. A short press on the button keeps the device switched on for another
10 minutes and will not change the mode.
1
44
2
3
Change function
When the device is switched on, the mode can be changed by pressing the button.
Each press changes the display mode in this order:
iAQl mode => Integrated Display mode (PM2.5 / VOC / Co²) iAQI (=indoor Air Quality Index)
=>WHO mode =>PM Mode (PM2.5 / Pm10) => VOC Mode
=> Co² Mode => Temperature / Humidity Mode
2. LED Status
The Status button gives
an indication of the
current air quality
Unhealthy
Poor / Bad
Moderate
Good
Unit measurement
µg/m³
PM2.5
0 - 15
16 - 25
26 - 35
36 -<
ppm
VOC
0.000-0.220
0.221 - 0.660
0.661 - 2.200
2.201 - 10.000
Pm10
0-30 31-51 51-70 71-<
Co²
Good Moderate
Poor/Bad
Unhealthy
(400 - 700)
(701 - 1000)
(1001 - 2000)
(2001 - 10000)
We thank you for having chosen the HUMA HI-150.
You are now in possession of a device with which you can immediately monitor the air quality EVERYWHERE, both indoors and outdoors
to check. HUMA HI-150 measures: CO2 - VOCs - PM2 - PM1 - TEMPERATURE and HUMIDITY.
Un mode d’emploi en français peut être téléchargé sur le site www.pinewoodelectronics.com
Een nederlandstalige handleiding kan gedownload worden van www.pinewoodelectronics.com
To Next Page
Need help?
General