Human Touch HT-Reflex 2 - Getting Started; Setup and Operation Guide

5
humantouch.com
4
1. Plug it in
Plug the power cord into an appropriate power source.
2. Power on
Turnthemasterpowerswitch(ontherearlowerright-handcornerofthemassager)toOn.
Your foot and calf massager comes fully
assembled. Simply plug it in, take a seat and
you’re set to go!
3. Position your foot and calf massager in front of your favorite chair.
4. Take a seat.
5. Place your feet all the way into
the foot and calf massage wells.
Sitting or standing on your foot and calf massager could result in personal injury and or permanent damage to the massager.
get ready
NOTE: Follow the below steps to remove your feet from the unit in
the event of a power failure:
1. Liftyourkneesupward(Fig.1).
2. Rotateyourfeetsidewaysandeasethemout(Fig.2).
Fig. 1 Fig. 2
ENGLISH