Human Touch HT-100 - User Manual

It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 3
HT-100/102/103/120/410/
430/450/3100/3200/3300
Tools Required: two small pliers, small Phillips screwdriver, small flathead screwdriver NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
1. Use both hands to pull the right-hand side panel off the chair.
2. Locate the footrest cable (Fig.1).
3. Scrape off the hot glue from the top of the handle where the cable comes through the handle (Fig.2).
NOTE: Some chairs may secure the cable to the handle using a small metal clip. In this case, use
a flat-head screwdriver to remove the clip.
4. Using two pliers, loosen the two nuts on either side of the black bracket until the cable is loose enough
to pull out from the bracket (Fig.3). NOTE: Loosen the upper nut completely.
5. Pull the able down to detach the barrel from the bracket.
6. Push the cable up, so the barrel on the end of the cable is above the handle.
7. Rotate the barrel 90 degrees so it will fit through the slot on the handle, then pull the cable through the handle.
8. Using a Phillips-head screwdriver, remove the screws that secure the cable guides underneath the chair, freeing the cables.
REMOVING THE FOOTREST CABLE FROM THE HANDLE
September 19, 2011
(Fig.1)
Footrest cable
(Fig.2)
REPLACING THE FOOTREST CABLE
1
Scrape off the hot glue
(Fig.3)
Nut

Summary

Removing the Footrest Cable

Remove Cable from Handle

Instructions to detach the footrest cable from the chair handle, including scraping glue and loosening nuts.

Determine Chair Version

Identify Chair Version

Procedure to determine if the chair is Version 1 or Version 2 based on seat cushion support.

Removing Cable from Bracket

Version 1 Cable Removal from Bracket

Steps to remove the footrest cable from the bracket for Version 1 chairs.

Version 2 Cable Removal from Bracket

Steps to remove the footrest cable from the bracket for Version 2 chairs.

Installing the New Footrest Cable

Install Cable into Handle

Instructions for inserting and securing the new footrest cable into the chair handle.

Install Version 1 Cable into Bracket

Steps to install the new footrest cable into the bracket for Version 1 chairs.

Install Version 2 Cable into Bracket

Steps to install the new footrest cable into the bracket for Version 2 chairs.

Completing the Installation

Test Footrest Handle Operation

Procedure to test the footrest handle and adjust cable tension for proper function.

Human Touch HT-100 Specifications

General

Type	Massage Chair
Heat Function	Yes
Dimensions	42" L x 28" W x 34" H (Upright), 61" L x 28" W x 28" H (Reclined)
Weight	75 lbs
Adjustable Intensity	Yes
Timer	Yes
Massage Techniques	Kneading, Rolling, Tapping