Human Touch HT-100 - Owner's Guide Manual

REMOVING THE MASSAGER
1. Power off the chair and unplug it.
2.
Use the footrest lever to fully deploy the foot and calf massager (Fig.1).
3
. Standing in front of the foot and calf massager, detach the upholstered flap
that
covers the massager
frame, then detach the seat pad from the chair base
(Fig.2)
.
4. Locate the hinge pin that secures the footrest actuator (cylinder) to the front of the chair frame (Fig.3).
5. Using a needle-nosed pliers, remove the C-clamp from the right-hand side of the pin (as you’re facing the foot
and calf massager).
(Fig.3).
6. While supporting the foot and calf massager, use a pliers to pull the pin to the left,
out of the
footrest actuator (cylinder)
, and remove it
(Fig.3)
. The
footrest actuator (cylinder)
drops down, away
from the foot and
calf massager frame.
Seat padSeat pad
Upholstered flapUpholstered flap
(Fig.2)
1
REPLACING THE FOOT AND CALF MASSAGER
May-04-2009
Tools Required:
Phillips-head screwdriver, flat-head screwdriver, vice grip, small hammer, pliers, nail clipper or other instrument suitable for cutting zip ties, new zip ties
NOTE:
SAVE ALL PARTS FOR USE DURING REASSEMBLY.
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL:
3
F
F
ootrest actuator
ootrest actuator
ootrest actuator
(cylinder)
(cylinder)
(Fig.1)
(Fig.3)
Massager
HingeHinge
pinpin
C-ClampC-Clamp
Bottom view
Bottom view