5
ENGLISH
humantouch.com
4
get ready
Assembling your massage chair is easy! Simply plug in the power
cord and you’re set to go!
When deciding where to place your SANA, consider the following:
• Place the unit on a flat surface, away from direct sunlight or any other direct heat source (to avoid fading).
• If you wish to place the unit on a hard surface, it is recommended that you place a piece of carpet or a soft mat
underneath it to avoid damaging the floor (minimum 48” x 28”).
• To accommodate the footrest when deployed, make sure the area in front of the chair is clear for at least 6”.
Choose a location
Clearance
6”
Recline
clearance
4”
CAUTION: To avoid injury to yourself and damage to the product, have two or more people move the chair.
Move the chair to the desired location
1. Push down on the backrest to tilt the front of the chair upward. WARNING: Do not lift the chair by the footrest.
2. Roll the chair on its casters to the desired location.
3. Gently lower the chair all the way to the floor: WARNING: Dropping the front of the chair to the floor may damage
the chair and/or floor.
Unpack the box
Chair
Warranty terms
Use and care manual
Spare fuses (2)
250V, 5A
Power cord
WARNING: DO NOT LIFT
THE CHAIR BY THE FOOTREST
X
Caster
To Next Page
Loading...
