EasyManuals Logo

Humanware Victor Reader ClassicX 3.3 User Manual

Humanware Victor Reader ClassicX 3.3
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
HumanWare
www.humanware.ca
Victor Reader ClassicX 3.3 User’s Guide
2
V6
To insert and play a new book
Turn On Victor Reader by pressing and holding the Power key, which is located above the Eject
key on the face of the player. You will hear a beep and a Welcome message.
Insert your CD in the slot, which is located on the front side of the player. Gently push the CD
forward. The drive mechanism will take over and finish inserting the CD. After a few seconds,
Victor Reader will announce the title and start playing the book.
NOTE: If you accidentally insert a CD upside down, it will be ejected within 15 seconds without
damage.
You can adjust the Tone, Volume, and Speed by pressing the keys up or down. The Tone,
Volume, and Speed control keys are located on the top center of the face.
To move back or forward at high speed in the book, press and hold the Rewind or Fast-Forward
key until you reach the desired spot, then release. The normal play speed will be resumed.
To pause a reading session
To pause a reading session, simply press the Play/Stop key. To resume reading where you left
off, press the Play/Stop key again. Note that if your player is not connected to a power outlet,
and if it stays in pause mode for more than 30 minutes, it will shut Off automatically to save
battery life.
To end a reading session
To end a reading session, simply turn the player Off by pressing and holding the Power key.
Victor Reader will remember where you left off in the book for your next reading session.
To start a new reading session
To start a new reading session in the same book, turn On your Victor Reader by pressing and
holding the Power key. After a few seconds, you will hear the title of the book, a beep and
reading will start where you left off in your last reading session.
To eject a CD
To eject a CD simply press the Eject key. Victor Reader will announce Eject and after a few
seconds the motorized mechanism will gently slide the CD out of the drive.
This completes the Getting Started session. The User's Guide will begin playing momentarily.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Humanware Victor Reader ClassicX 3.3 and is the answer not in the manual?

Humanware Victor Reader ClassicX 3.3 Specifications

Battery IconBattery
battery typeRechargeable NiMH battery
battery voltage7.2 volts
battery capacity1800 mAh
Operating Environment IconOperating Environment
operating temperature10-40 Celsius
storage temperature-20-35 Celsius
humidity5-90%
Ports & Interfaces IconPorts & Interfaces
power jack2.5 mm (interior)/ 5.5 mm (exterior)
line out, earphone jacks3.5 mm
remote jack2.5 mm
Weight and Dimensions IconWeight and Dimensions
dimensions23.7 X 20.9 X 5.4 cm
weight1.1 kg

Related product manuals