What to do if the ramp wall on my Humbaur Utility Vehicle is hard to lift?
If you're finding it hard to lift the ramp wall on your Humbaur Utility Vehicle, it could be due to weak or defective gas struts. It is recommended to have the gas struts replaced in a specialist workshop.
Why is the cover on my Humbaur 2000 hard to lift?
If the cover with gas struts on your Humbaur Utility Vehicle is difficult to lift, the gas struts may be too weak or defective. The suggested solution is to have the gas struts replaced in a specialist workshop.
General| Brand | Humbaur |
|---|---|
| Model | 2000 Series |
| Category | Utility Vehicle |
| Language | English |
Confirms compliance with EU directives for registration and safe use of trailers.
Lists and illustrates various parts of the HA and HT/HN trailers.
Details HA trailers with anodised aluminium drop sides and specifications.
Details HN/HT trailers with anodised aluminium drop sides and specifications.
Illustrates special versions like ramp walls, tarpaulin covers, and long drawbars.
Presents various optional accessories like H-frames, covers, and ramps.
Specifies intended use for HA and HN/HT trailers, including vehicle transport.
Lists foreseeable misuse scenarios for HA and HN/HT trailers.
Details correct load distribution for trailer stability and component protection.
Explains how to properly secure loads using form-fitting and force-fitting methods.
Covers marking requirements and safety for loads projecting beyond the trailer.
Details various tie-down points and their maximum load capacities.
Explains operation and safety for drop sides on HA and HN/HT trailers.
Details functional explanation, opening, and unlocking of drop sides for HN/HT.
Explains operation and safety for front and rear drop sides on HA trailers.
Describes the optional rear drop side held open by a support rope.
Details the optional side wall extension to increase loading volume.
Explains the optional two-part drop side with centre stanchion for HN/HT.
Describes the optional raised drop side of 500 mm for HA, HN, and HT trailers.
Details the optional steel mesh extension for HA trailers to increase loading volume.
Covers optional supports, including telescopic prop stands for HN/HT.
Explains the functional aspects and operation of telescopic prop stands.
Describes the optional prop stands, their fitting, and operation.
Details the wood/aluminium cover for protected transport and its operation.
Describes the flat cover, its bracing, and fastening rope for preventing unauthorised opening.
Explains the tarpaulin cover with frame, its fixing, and opening for loading.
Describes the swing-out frame for easier operation of cover parts.
Details the lateral sliding tarpaulin where side cover parts can be slid open.
Explains the tarpaulin cover fitted and secured directly to the chassis.
Covers the ramp wall for loading with forklifts or rolling containers and its operation.
Details the H-frame for transporting and securing long loads.
Explains the aluminium drive-up ramps for loading vehicles and their specifications.
Details the optional cable winch for pulling defective vehicles onto the cargo bed.
Describes the optional grid ramp wall for loading vehicles onto HA trailers.
Covers the optional toolbox for storing tools and accessories.
Details the toolbox mounted on the drawbar for HA versions.
Details the toolbox mounted on the chassis for HN/HT versions.
Details manual manoeuvring and parking procedures for an uncoupled trailer.
Provides instructions for general cleaning and care of the trailer.
Guides on maintenance and servicing, referring to other manuals and specific instructions.
Details checks for tyre pressure on all wheels.
Explains gas strut function, maintenance, and safe removal/fitting procedures.
Details procedures for securing the trailer against unauthorised use and parking.
Guides on how to dispose of the trailer or its parts at a recycling facility.
To Next Page
